Change AD User Password The Change AD User Password activity changes the password for an Active Directory user account. This activity requires the user's current password to run, unlike the Reset AD User Password activity. If the new password violates any Active Directory password requirements, such as length or character combinations, the activity fails and returns the appropriate error message. This error message appears in the ECC queue and in hint text when a user points to the activity in the workflow editor. To access this activity in the workflow editor, select the Custom tab, and then navigate to Custom Activities > Active Directory.Note: This activity replaces an AD activity by the same name available in releases prior to Geneva. If you have a workflow that uses the deprecated activity, your workflow will continue to work normally after upgrading to Helsinki. However, all new workflows must use the custom version of this activity, which was built with the Powershell activity designer. Input variables Table 1. Change AD User Password input variables Variable Description DomainController IP address of the domain controller machine. User The sAMAccountName of the Active Directory user account. New_password The new password to assign this user. Old_password The user's current password. Output variables Table 2. Change AD User Password output variables Variable Description result One of the following outcomes: failure success Policy Failure Incorrect old password errorMessage The executionResult.errorMessages from the Activity designer parsing sources. hresult Powershell command result. Conditions The activity provides the following conditions:Table 3. Change AD User Password conditions Condition Description Success Password successfully reset. Policy Failure Password does not comply with the organization's Active Directory requirements. Incorrect old password Password being changed was not entered correctly. Failure An error occurred while attempting to change the password. Additional details may be available in the workflow log.