Configure event collection from Zabbix The Zabbix connector instance requires configuration prior to receiving alerts from the Zabbix server. Before you begin Role required: evt_mgmt_admin Procedure Navigate to Event Management > Connectors > Connector Instances. Click New and create a connector instance with the following details: Field Value Name Type a descriptive name for the connector. Host IP Specify the Zabbix IP address. Credential Select a credential that uses Basic Auth. The format for the User name is domain\username. Read-only permission is sufficient. Schedule (seconds) The frequency in seconds that the system checks for new events from the Zabbix server. Description Type a description for the use of the Zabbix event collection instance. Connector Definition Select Zabbix. Last error message The last error message is automatically updated. Last run time The last run time value is automatically updated. Last run status The last run time status is automatically updated. MID Servers (MID Server for Connectors section) For cases in which the connector cannot be determined from the IP address range defined on the MID Servers, such as in a multi-domain set up, select the MID Server to run the Zabbix connector instance. Right-click the form header and select Save. The parameters that are relevant to the Zabbix connector appear. In the Connector Instance Values section, specify the Zabbix values. days from Specify the number of days that have passed for which events must be collected. Default value 2 days. Note: The maximum number of past events that can be collected is 3,000. The first time that this connector runs, the number of past events is counted in the past from the current date. In subsequent runs, the 3,000 maximum number of past events collected is counted from the last event that was collected. port Default value 80. Right-click the form header and select Save. Click Test Connector to verify the connection between the MID Server and the connector. If the test fails, follow the instructions on the page to correct the problem and then run another test. Tip: Use a network tool, such as ping, to verify that the SCOM server is running and the IP address matches the value in the Host IP field. After a successful test, select the Active check box and then click Update.