Thank you for your feedback.
Form temporarily unavailable. Please try again or contact to submit your comments.

Check an indicator source

Log in to subscribe to topics and get notified when content changes.

Check an indicator source

Verify that the sample indicator sources match your configuration.

Before you begin

Role required: pa_admin, pa_power_user, or admin


  1. Navigate to Performance Analytics > Data Collector > Indicator Sources.
  2. Open one of the sample indicator sources.
  3. Go to the Source section.
  4. Change the Facts table, if needed.
  5. Change the Conditions, if needed.

    A good indication to see if the conditions are set up correctly is the number of matching records found. Click the matching records link to view the results in a new tab. Check to see if these are the expected records based on the conditions.

  6. Click Update.
  7. Repeat this procedure for each sample indicator source.
    Note: For Eureka Patch 6 and later versions, including Fuji, if an indicator source has a condition on a field or column that does not exist, the condition does not appear in the UI (although it is there). Therefore, you cannot change the condition through the UI. Instead, you can export the XML and import of the indicator source record.